SheenPlus

• TDS - SheenPlus (EN)
• Leaflet - SheenPlus (EN)

Application on furniture and tables

1. Let the Oil Plus 2C dry for at least 24 - 36 hours.
2. Thoroughly mix the two SheenPlus components together for 1 to 2 minutes, ensuring a ratio of approximately 3 units A to 1 unit B.
3. Apply a small amount of SheenPlus with a brush and spread further with a red Scrubby Pad. Within 15 minutes, go over the same surface again with the red Scrubby Pad without adding additional product.
4. Wipe again with a white Scrubby Pad.
5. Remove any streaks and/or surface irregularities with a lint-free cloth.
6. Let dry for at least 24 hours before light use of the surface. To ensure effective drying and curing, it is important to maintain proper ventilation and temperature. Full curing takes place in 7 days.

Application on floors

1. Let the Oil Plus 2C dry for at least 24 - 36 hours.
2. Thoroughly mix the two SheenPlus components together for 1 to 2 minutes, maintaining a ratio of approximately 3 units A to 1 unit B.
3. Apply a small amount of SheenPlus using a floor buffer with a red buffer pad. Spread the product to ensure no irregularities are visible in the treated area. Optimal treatment areas are between 20 to 40 square feet, avoiding excessively wide spaces. Ensure that the floor buffer can be maneuvered easily without stepping into the wet product. TIP: If the layout of the area being treated does not allow you to work without standing in the still wet product, use (half) a white pad to stand on during application.
4. Within 15 minutes, complete the treatment for the area using a white buffer pad until the surface becomes uniformly even and dries to a rub-off finish. Use a lint-free cloth to remove any streaks or irregularities in the surface.
5. Repeat these treatment steps across the entire surface in segments that can be treated within a 15-minute timeframe.
6. Allow the treated surface to dry for a minimum of 24 hours before cautiously walking on it. To ensure effective drying and curing, maintain proper ventilation and temperature. Full curing will occur over a period of 7 days.

Renovation/maintenance

If the product starts to show too much wear (traffic pattern), you can easily solve this by applying a new coat. First, make sure to remove any dust and dirt prior to applying a maintenance coat. Refer to the steps on pages 2-3 for the proper cleaning and application instructions.

When Oil Plus 2C color wear is evident, first perform a repair/renovation with the original Oil Plus 2C color (Part A & B must be used for the color restoration). After that, let dry for at least 24 - 36 hours. Then, apply SheenPlus to the repaired area and let it dry for 24 hours. After that, apply SheenPlus to the entire floor surface.